Search results

The best I can do is direct everyone to Amazon. The Light housings are LED Corner Fixtures 90 degrees with 45 degree internal mounting space that is 10mm wide. The LED strips are 4mm, 600 LED per 16.5 feet, Red color LEDs. Those are the main two components you need to make the lightbar.

Check out my post, i built my own.

Another light could be added and be much closer to the factory taillight dimensions. I was more concerned with the tilt of that section of the tailgate and getting the color to match. I was thinking about adding a second but, I thought it would be over powering. Maybe one strip each would be...

I am lucky with the Flash, the decals are vinyl and would be easier to remove. I have had stickers, plaques, emblems from dealerships before that were terrible. This dealership was fantastic, I had to search out several dealerships to find my truck. They acted like, they were doing me a favor...

Not really, the LED strip wires were thin like 20g. I used red and black low amp wire from my security camera system. The tailgate movement was not bad, I just used a couple of finger widths to offer spacing. I have small pressure retainer wire clamps that really helped. Adhesive clamps, little...

I made the mistake of posting it on FB and was flooded with order requests. I posted the process and not many were happy with it. Buy it sure, do it, not so much... Thanks for the recognition.

Well, I did it. My 2024 Flash did not have the EV trademark Taillight to Taillight red light bar. After a few weeks of research, a few lucky finds, a great deal of trial and error, I built my own tailgate light bar. After posting on FBook and getting over 400 order requests, I had to walk away...

Ok, I see. I've read that tying into the trailer harness will trick the truck into towing mode and turn off rear sensors and cameras and range estimates.

Thank you Watts. I will find something or figure it out if, I am disassembling my truck.

Did you remove a tail light and just splice into the wiring? If so, do you remember what the color of the wiring set up was? I am going to add a red running light across the tail gate since, my flash didnt have one. Plus, I need to splice into the front turn signal wiring too but, can't find any...

Hi Watts, I seen that and seems a bit overly complicated just to add switches regardless. I am surprised nobody has a color chart or diagram of the wiring harnesses. Maybe, I am stuck in 2011 Crown Vic mindset but, it cannot be this hard haha.

Hello, After hours of searching, reading, asking for help, nobody has been able to identify the headlight, taillight, running lights, DRL wiring color codes, harness diagrams or much information. I have two hood mounted Pod Lights with a small accent light for marker / DRLs and amber for turn...

Which wires would I tap into to power the DRL and Turn signals for my new light pods accent lights?