Recent content by emmelj

I just got the BCM update from Ford. WAL feature not showing up in SYNC settings, but I get a notification on phone while at home, that WAL was activated, checked truck and it is indeed locked. While out and about today, WAL didn't activate when away from truck. Come back home and WAL...

Yep, same message.

Anyone get high voltage battery warning after turning on climate for awhile? Climate ran for about 10 minutes before I got in the truck. The message is gone now, but worried something else is going on. I'm gonna try running climate again to see if it triggers the warning again. @Ford Motor...

After a rain mine would smell also. Culprit was that mesh part.

I drove it for the day. Same thing. start it up, 100%, then after putting it in drive, it would drop to 56%. That day, I had turned it off and on numerous times while running errands. Finally, disconnecting battery did the trick.

fixed. disconnected battery.......

Receiving 1/2 power, only rear motor after update. No errors or notifications. Any suggestions? @Ford Motor Company

Was just at Bill Utter.....they have some installed. Didn't pay attention to them so couldn't tell you the specs on it.

Same thing happened to me. Dealer was 3 weeks out. Ridiculous. I just dropped it at the dealership and said its undriveable. They had it 2 1/2 weeks. Ended up being a rodent chewed one of the frunk wires. Replaced the whole latch, $700! Then the ended up breaking the plastic piece that...

Well.....parking outside sucks. It was a rodent that chewed a wire connected to the frunk latch.

In the shop. In person visits seem to work better than phone! Will update when fixed.

well....tried about everything. The consistent chiming makes it un-drivable. Going to the shop...in 2 1/2 weeks! what bs @Ford Motor Company

I have not. Is that in the manual?

Got in the truck this morning. Said frunk was open. It was not, so I opened and closed it numerous times. Rebooted. Turned truck off and on. Truck still thinks its open. Any pointers? @Ford Motor Company

I am using the tesla tap mini. While using the Lectron adapter, the handle was overheating from the Tesla charger, but would never overheat while charging the Tesla M3. I assumed it was the charger itself and Tesla replaced it. Put the new one in and it was still overheating. Switched to the...