Recent content by Hullguy

Scheduled my 221 for the insulation recall. The dealer is going to take care of this and the trailer take recall on the 14th

Love it!

The puddling is minimal. I put the gaskets on and they had little effect.

8” on the canister. I ordered the rebranded Factory installed one. It was roughly the same cost. It is substantially dryer than the one I had on my 2013 FX4

I’m going to be called a heretic! These stock Hankook Durapros are fine in the snow! This is after driving in a 30” storm, an ice storm and last nights 8” dump

It doesn’t work like that! Each hot leg is fused at 30 amps! Each hot leg to ground or neutral is 120 volts

If it is plugged into a 50amp, 240volt receptacle. If plugged into a 30 amp 240 volt receptacle the power source will only ever supply 7200 watts.

It doesn’t work this way! Travel Trailers that run on 30 amps are only using 120 volts. The bigger trailers with 50 amps run on 240 volts. The 240 volts is split into 120 volts at the trailers electrical panel

Not at all!

You can pick up a strong 3M double sided tape at Lowes. I think it’s in the paint section

That worked! Ty

Im getting the same error with the new script.

Thanks for this Tonesto! Im getting an error. Thanks

I used some Dawn dish soap on the sides. Slid right in

Thanks for the wire up. I have a 2375 as well. Who makes the box on the back of your trailer?