So I've got a 302A with 360. So my IPMA may be good.
If I was gonna give this a try it sounds like I need:
wiring - ML3Z-15K867-B
ccm - ML3T-9G768-AH
switch - SW-7449
That correct?
sorry for the full n00b question here because I'm obviously missing something...
downloading my AsBuilt data from the widget (reloaded) or even directly from motorcraft shows me old values. I made the changes in forscan over a week ago now.
Why are they not getting uploaded?
Since the ECU thread is so large you may not have seen it -> there is a bunch of us in the same boat with XLT 302A trucks all stuck at 2.3.0 even updating manually with FDRS.
Nope. 302A with here stuck on 21281 revision 244.
Never got an IPMA update at all.
However I do have cameras in motion enabled through forscan changes. But the bed camera side card won’t work without an IPMA update.
However @JaHoova is on the same with a 302A and DID get an IPMA updateand has...
Nice find. Tested this on my XLT 302A with 360 and now I do get the front camera turning on when switching to mud or rock crawl automatically (it wasn't before). But no tire indicators like above. Could be because I got stuck at 21281 v244? Or is there something else that could enable that...
Thanks, had the above already for at speed. Then enabled the IODBC with
APIM 7D0-01-03 xxxx xxxx xF--
The bed camera card shows up now but its blank. Nothing else in forscan seems to enable more. So seems like it's an APIM/IPMA update needed. So not sure how yours is working if you were stuck...