Recent content by OIF_VETERAN04

You could just tap into the existing ones. It would make it easier. Then you won't have to remove the existing wires. Also you won't have to worry about unpinning then. It will also save you money on the pins or the pre-wired pins from ford.

Yes that's what I did it worked great. Best mod you can do. The pig tail from ebay is made just for doing this. Only has the wires you need the ones you don't are sealed off so it is water tight.

I redid all of the forscan changes. It is working perfectly. I talked to Jesse-Infotainment on the other forum he told me exactly what I did wrong and gave me the correct change for the BCM. Thank you for all of your help

I will definitely do that. I know this is for the lightning. So as I went through the changes I checked the spreadsheet. But I definitely did enter the wrong change somewhere. Thank you for your help and thoughts on my issue.

I quadruple checked the wiring harness I made as I was doing it and after I installed it. Cause I was paranoid about putting the wrong wire in the wrong place. So I know that is all good. I'm sure I made a mistake doing the forscan. So I will redo it all, now that everything is back to factory...

I reverted everything back to factory ab and am still getting ABS DTC's. I'm going to have to try again tomorrow to forscan everything. My laptop is dead lol

I cleared the codes. But it just keeps coming back with ABS codes. I checked the forscan that was done to the ABS but it's correct.

@ZSC100 I got everything done but now my truck has errors on the screen for per-collision assist not available and service AdvanceTrac.

Which connector?

The ebay pigtail only come with the 4 wires you need the other side is already sealed off.

@ZSC100 I ordered the CCM pigtail from ebay for $40. The dealership...

I could just do that. I'll have to research upgrading to the led. I ordered it for a dealer online.

Do you know what the part number is for the CCM pigtail? The harness I got is for led fog lights and I have halogens. Plus the part number I ordered matches the number on the box but the tag on the harness in the box is a different part number. LMFAO

Ok so at the bumper harness connector the 4 wires are there but at my IPMA they are not. Has anyone else run into this problem?

Does anyone know the part number for the harness that is halogen and not led?