Recent content by RellIk&5

Is everyone with an 8” cluster and no 360 cams still stuck on 244?

The main missing feature would be camera in motion.

So no one with an 8" cluster has gotten past the 244 version of software? Are all of us 8" cluster people stuck and not able to get any additional upgrades?

I get the exact same error.

Do you know which wire and in which of the two harnesses provides the power to the factory amp?

Curious about this, as well. One power run to the battery (positive AND negative) and then to a distro block? Use the distro block for powering the LC2 and the amp? Or are you splitting the power some other way? Actually found a few diagrams where people are running the power from the battery...

My F188 is MU5T-14G676-EG F124 is MU5T-14G677-ABA VIN is 1FTFW1E86MKD74376

...and I'm a 3.5 Eco

Hopefully that's the case. I feel a bit better knowing I'm not the only one with this configuration of truck that's not getting further updates.

Sync4 v4.0.21281

I am using the Widget.

I have an 8" center cluster.

I'm an XLT with non-bluecruise and non-360. I'm stuck at 244 and have been for at least a month (after doing my initial updates via the nano.). I got my mongoose over a week ago, applied a few updates, but have not been presented with any additional updates to move beyond 244. My VIN is...

What was your F188 part number? Mine is ML3T-14C026-BAK. I don't have the F120 listed in my IPC list. Maybe that's why I'm not getting any updates beyond what I got last week???

It's been over a week for me since I applied my last batch of available updates. My rev is still 244. Can someone please check this vin to let me know if there is anything new aside from the GSM? 1FTFW1E86MKD74376 Thanks!