Search results

Mine just shit the bed

Love it

It's cabin overtemp and no just the dealership told me there were a few errors. FYI don't run your truck without the frunk tub in place the truck freaks out. It must use the 120v plugs for something.

Mine has its on pump if it senses no water flow it shuts off how it does that I have no idea

Can't put a thermostat if the pump fluid goes to slow it throws errors and shuts off

It can help heat the battery if the truck calls for it. But it won't heat them driving down the road There's been a few issues but other than that has been great honestly the biggest issue is I can turn it down. Gets pretty hot inside the truck. There has been 0 holes cut or anything done to...

I think mine is 8,000 and it's descustingly hot. I tried running the pump in series and parallel and series is way better. The heater core is labeled in and out. They way I have mine set up is the fluid leaves the heater core and directly into my webasto intake. than the fluid reconnects back...

So at -30 I run diesel heater and eheat still more efficient than strait electric

Heater running not sure why videos not working

Small video of the new install leaving front off till I run it and confident I won't melt anything. So temp install diesel tank and should be fine

I took it out in the spring so I can permanently install it this fall, I can make a small video installing it. Yes you still use the heat controlls In the cab. And the webasto heater has Bluetooth so no display just on my phone

Your not understanding the problem imagine if it was water you have two taps that put out very little flow to get more flow u combine them into 1 hose That's what the transformer is doing is combining both legs into 1 to get more flow aka current sharing. Your idea still only uses 1 leg. I...

Our mixer Will melt cheap electrical cords it basically pulls 20 amps I assure you it's my 3 mixer and there all the same your comparing something that's supposed to be efficient to something that mixes concrete. It pulls steady 1500 watts and if your mixing heavy it's 2000. There's so much...

Was it an inductive load. Probably not did it have a surge of 5-10,000 watts so 40 to 80amp surge doubt it.

It doesn't trip the 20.amp breaker. breakers are designed to be tripped by heat. The inverter has 0 overload so for a split second I bet it pulls 5 to 6000 watts and the inverter can't handle it. It's a high frequency inverter not low. So it's mossfet based not transformer. Which means it sucks...

That adapter still only uses 1 leg of the inverter

You mean the dust?

It's mixing concrete even a new mixer will still pull alot when mixing. The only other option was to replace with a 240v motor but that would make it difficult everywhere else to get power

She works hard yup almost 54000km