Search results

I think I am out of luck. The space between the bolts is 16"s and the sub is 18.5"s. I removed the carpet and the seat cannot raise with the sub there. I couldn't get the seatbelt stud out to make it sit low.

I guess I am special, I keep smashing the sub and hitting the bolt for the seat. Any recommendations @BennyTheBeaver ? My setup on a 23 looks different too as I have a bracket for the amp. https://photos.app.goo.gl/Z8QF1UbUbWfmKGLf6 I am thinking about trying to replace the post with a bolt to...

Thanks, I just glanced at it. I will play with it next weekend. Thank you

What did you guys do to make the Microsub fit with the center seatbelt post?

If anyone is interested, I will sell them the distance sensor without the bracket for $250 shipped. I sold my XLT and upgraded to a Lariat. Rather than pulling the whole truck apart, I just removed the sensor. I did crack the holder housing, not the sensor, and glued it back. You can see it on...

Yep, same exact message that made me reset my CCM and try again.

I had to program my CCM twice. Try resetting it under the same menu and double check your settings.

It is the first X characters composed of the screenshot settings. If the screenshot is 1234 and the CCM screen is 987654 it calls for XXX** it becomes 123454.

Amazon sells harness tape made of fabric. Tesa's Most Advanced High Heat Harness Tape 51036 Mercedes, BMW, Audi, VW https://a.co/d/6ZigS0P

Great Success. It is working after resetting the CCM and calibrating again. Thank you everyone for the guidance.

Lots of progress today. The custom harness is installed and CCM is configured. Getting through the FW was a pita. After collaborating the CCM, the error message on dash is gone about CCM alignment. Next hurdle is that I am receiving " Adaptive Cruise Control is not available".

This has been claimed.

If anyone is needing correct color wires, male pins, splice connectors, and harness tape I will sell the other 12' of my four wires, 6 pins, 4 connectors, and role of harness tape for $25 shipped (half the cost minus shipping).

Do you happen to have that picture outlining the pin location within the harness in your video? Just trying to be safe. Hoping to complete this Friday pending parts.

Thank you. I have requested the custom wire colors. Did you leave the wires out of the boot after the splice bypassing the connector? What type of splice connectors did you use?

This was way over my head until I figured out which connectors those were. I will wait on pics so I know which wires to see if available. If not, I guess I will be running wires.

Is it possible the wiring is different in the boot if it has the fog lights in the cord? I don't have any power to the CCM plug. Does your forscan settings match posted on the link?

1FT6W1EV0NWG05515

The plan for today is to compare my 311A to a 312A asbuilt. After reading the other forum, the reason the pros are having issues is the 360 camera is a prerequisite to have the wiring.

22 and it had the wires in the boot.