Search results

Not a dumb question, but yes; you'll need to trim about 1/4" off the shifter front tab. When I was working on my model I wanted the shifter as far forward as possible and the cupholder takes up so much space in order to keep the walls thick enough that was the tradeoff I had to make. Section...

I used Bambu GF PA-6 on a P1S. I have to turn the print up 45 degrees to get it to fit within the build area but it has the added benefit of making the layer lines invisible. I think the CF filled version might match a little closer to some of the other nearby trim pieces, but the GF does just...

I believe the ford PN is listed on the other side (or underside, I can't remember exactly). In any case, the escape shifter i purchased had that same number on the right side (you can see it in the attached image)

BLUF: It's possible but requires making a wire harness jumper in order to reach. See Post #14 on this thread: https://www.f150lightningforum.com/forum/threads/rotary-shifter-possible.18630/post-406413

I ended up doing this with the Escape shifter in a Glass-Filled Nylon (PA6). I've had good luck with the heat resistance of Nylon compared to the standard PLA or PETG. I like the finish the GF gives the print, so I'll probably just leave this "in the white" so to speak. Regarding UV exposure, I...