Search results

Yea must be a part of one of the packages. I don’t have either of those packages nor on board scales. I have a base 22 XLT 311.

Tried out smart hitch and it said I needed to see a dealer so I removed it by changing the line below. Apim 7D0-01-04 xxxx xxxx x2--

Just added in the Zone Lighting thanks to @LUXMAN and @GDN. I only needed half those values as some were already that way on my truck. It also appears to have added smart hitch which I didn’t have before. I wasn’t able to drive it right now, but will check it out later if I can. Also to note...

Nice work! I tried to get this working before but couldn’t figure it out. Will definitely try to add this to mine this week.

Did you enable it on the trucks screen settings?

Only other thing I would suggest would be to reach out to Forscan and let them know of the issue. They may have a beta version for you to use. You’ll have to pay for the license which is like $12.

If you have the green A it worked. They need to be enabled in the setting menu on the truck screen. Then once you are out driving the truck needs to be going over 34mph and be on a dark road without street lights. Think like a back woods road.

I believe you have enable the rain sensing for every driver profile, including the guest profile.

I haven’t. I don’t take my dog or kids anywhere and leave them in the truck.

I just enabled it on my 311 XLT. Did you force reset the apim module? I also cleared all dtc’s after the reset. Worked fine for me. Removes black box from the rear view when in drive. Also gives the radar warning for the front in the corner view until you switch back to the 360 view.

Just saw there were some new updates to the Forscan excel sheet. I haven’t been able to test them yet but knew there would be some interest. Remove "full view not available" Pet mode?

@Mike G

The only thing I’ve found so far are these. Which I have to believe the dealer could do for cheaper. https://www.ebay.com/itm/274871252940?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=OVeR-Uq5R7q&sssrc=4429486&ssuid=aE6EpsctSQS&var=&widget_ver=artemis&media=COPY

If the “A” turns green when the headlights are on they’ll work.

Just finished this as well today. Everything is working as it should. Unfortunately I ran into a few issue which I would like to help the next person avoid. As jdmackes mentioned remove the speaker and loosen the lower window guide rail, it will make it much easier to fish the harness in and...

You can go here https://www.motorcraftservice.com/AsBuilt enter the VIN and you will be able to download the As Built

What I would recommend is go into the thread with everyone’s reservations and find a vin that matches what you are looking for. Then you can just pull the as builds instead of asking. I did the same thing for the glare free settings.

Did you ground it too?

There are small slot grooves in the top and bottom of the rubber “grommet”. They release an inner plastic clip. There are also clips without slots on the sides of the grommets. Think about it like a clock behind the grommet, inner clips at 12, 3, 6, and 9.

I found the same thing and bought the new part