Recent content by hb.sagen

The DTC on the TCU was gone now, and don't come back. They switched the modem from FB5-TCU-NA to FB5-TCU-ROW

Great, thank you for checking. The dealer enabled Fordpass. They installed another modem, or reflashed the old one. I have a config error in the tcu now, reported by forscan. I can check what modem is installed now.

Yes, the MME do.

Is there any way to see what updates that will come to my car? My main concern is getting the "diff lock" toggle in off-road mode. Now it is always locked when selecting offroad.

I did mount the camera and grill today. And the bottom of the hexagon needs to be trimmed, and more than I thought. Keeping the original angle of the camera, and cutting only one hexagon, will limit the viewing angle achievable because the body of the camera hits the grill itself. I will trim...

I finally got a FordPass activated, but the tech said I would not get any updates because there was only one Norwegian version, and switching to the US sw would break at least DAB. But activating DAB is only a switch in ForScan. And I prefer english in my tech anyways. But how do I let the...

After 4-5 different versions of a 3D-printet mount I finally got something that I will try on the vehicle. It replaces one of the hexagons, so easy enough to remove the backside of the correct one (when I figure out which). I belive the lower wall of the hexagon needs some trimming as well, if...

Did this solve your problem? I just got Paak, and now the car lights up whenever I go to the kitchen or the bathroom.

There is a ton of DRL options in the forscan excel sheet, under BCM.

We have to have our cars inspected every other year, by EU regulation. It costs a lot and any medium to major fault needs to fixed or the vehicle is delicensed. Mostly a good thing to get road unworthy cars of those. But, the number one cause of failure to pass is rusted disk breaks on EVs. I...

I bough one from AliExpress, arrived yesterday. Looks great. Hopefully I can install it sometime the next weeks. Oversizing the holes for the letters helped with alignment. Used an 9 mm drill bit. My plan is to print a mount in iterations until it is right. And make a small as possible hole in...

On wiring, I would like to not drill holes in my fuse box. We have 6 months of salty slush, and a lot of rain the rest of the year. The LEDs looks like they will not survive any length of time. The wire seals are poor and the sheath is open in a lot of places. Attaching the wires to another...

But my car is still in one piece :)

Did you ever make a CAD? I am going to print a holder, but I don't want to take the camera out to measure it. Or is it super easy to take the camera out?

Cool, have you tested BlueCruise in Sweden? They are enabled for BC