Recent content by HornetRaider

I didn't see it as an issue. Just make sure your truck is on while it's running the update and you should be good to go.

I had this happen. I power cycled, flash/reset, installed open pilot, uninstalled open, then installed bp7. Not sure if that’s correct, but that’s what worked for me. In the blue pilot doc, it says in all caps to install open first before doing bp7. I wasn’t sure if flashing the camera got rid...

It’s centered when traveling in a straight line, but it rides the passenger lane dividers on a curve. Is there a parameter I can modify to bring it more towards the center of the line while in a curve? I took a video.

I just upgraded to bp7 and am not able to toggle the lane offset. Truck is hugging passenger side pretty heavily. In lane offset toggle is grayed out and says fordpreflateralcontrol=0. I’m on angle mode, as I’m reading that’s the preference.

did you upgrade from 6.0? Do you have to flash/delete the comma to upgrade it to 7.0?

Likewise. I love that feature.

Yep, works on my c4 as well. I’ve noticed it only dings if I’m not looking at the light when it changes. If I am, no ding.

I have the same ding when I’m first in line at a light. I remember toggling this setting when getting everything up and going.

Do different models have different nanny sensitivities? The comma nanny is very sensitive. I was reading that it was less sensitive than ford’s, but it looks like they rolled out an update recently that made it more sensitive.

Voted. Is there a world where comma can integrate with a mapped destination, linked with this device, to get closer to self driving?

I finally got up and running. Really impressed with the WD-40 model. Only thing I've changed is the -.05 lane offset. Need to plug in the rest of the recommended settings. Is it just me, or are the attention alerts way more invasive on the comma than the native Ford blue cruise? Everything I...

The new usb cable came in. When I plug it directly into the c4, it works but doesn’t recognize the car. When I plug it into the dock with integrated resistor, I get the same issue. Says start the car while car is started..

Didn't work, unfortunately. I ordered the cable ajzride recommended. Should be in tomorrow.

I sent the required specs of the cable to our company's IT. He said he has a cable that fits the bill. Going to try it at lunch direct to the C4 to confirm, then to the dock, and if that works, I'll go through the trouble of tucking the wire again.

Thanks for sending him the signal!