• Welcome to F150Lightningforum.com everyone!

    If you're joining us from F150gen14.com, then you may already have an account here!

    If you were registered on F150gen14.com as of April 16, 2022 or earlier, then you can simply login here with the same username and password!

Sponsored

Search results

  1. BlueCruise - Trading One Annoyance for Another

    So, I’ve had BC up and running for a week or so now hand have used on a dozen or so drives. I find the “Watch the road” alerts to be as annoying as the “keep hands on wheel” warnings that were there before. If I glance at the radio or look down to the dash for more than a second, the warnings...
  2. ECU module programming guide using FDRS

    I noticed right away that it’s slower to pickup the lanes for lane keep assist - driving through town. Perhaps, even outside of BC it’s searching for a higher level of accuracy in lane markings than before. Perhaps it’s learning and will get beck to being quicker. A few times there’s a slow line...
  3. ECU module programming guide using FDRS

    Makes sense, I’m fairly familiar with engine tuning and it’s complex on its own. Throw EV motors into the ICE mix and it gets even more complex. A whole new set of variables to control for charging and discharge state in idle, acceleration, cruise, deceleration… all in various drive modes. Makes...
  4. FordPass - Scriptable Widget V2022.XX (iOS, iPad, MacOS)

    I am, still undefined. Is it the widget that makes it undefined or vehicle/ford/FordPass?
  5. ECU module programming guide using FDRS

    I had it prior, never removed it. Works fine. All my ForScan changes work fine. I had to renter a few after update.
  6. FordPass - Scriptable Widget V2022.XX (iOS, iPad, MacOS)

    My Module data shows 2 “Unknown Module”s, one is BECM and one is SOBDMC. Is that normal?
  7. ECU module programming guide using FDRS

    I tried the TSB 22-2117 OTA fix today. Didn’t work for me. I’m wondering if it wasn’t happy since I’m already updated past 1.7.1. I suspect there are 2 parts to this “fix”: one applies the APIM repair to allow for easier updates where we all struggled at 1.7.1 and the second is Ford fixing the...
  8. 1.7.1 install failed (no OTA "fix") Fix now at dealers

    I just tried to perform the Module Update Repair and got this message. I wonder if it’s actually going to work.
  9. ECU module programming guide using FDRS

    Never mind. Rebooted the APIM and it all Popped up! Thanks all!
  10. ECU module programming guide using FDRS

    I’m all out of updates. Currently at APIM 22034 354 and all modules green. I did get a ford pass blue cruise active notification. My Sync screen does not show any blue cruise information. my driver assistance settings don’t show anything to enable blue cruise. Any ideas?
  11. ECU module programming guide using FDRS

    I just installed the APIM for 22028 358 and the GWM is installing now. At which update should I see BC stuff? I know there are more after this GWM that will pop up, but seeing BC stuff show up will be a good status confirmation.
  12. ECU module programming guide using FDRS

    I just got a login loop. Restarted FDRs and seemed to work. Downloading ok it seems
  13. ECU module programming guide using FDRS

    So the GWM took. This is the list of modules updated in the last few days in order. I can’t be sure that the IPMA actually took with block 4 or not, but the USB validation certainly wasn’t done. I have no further updates in FDRS. IPC is still in progress though. ABS showed an update on Monday...
  14. ECU module programming guide using FDRS

    thanks, the GWM update started. In the reboot wait now. Let’s see what comes up when that is done.
  15. ECU module programming guide using FDRS

    ok, just picked up the truck andIPMA isn’t bricked. It’s green in fdrs. No updates available in fdrs but the tech doesn’t believe block 4 went through. I can’t tell exactly what’s going on, but I have a cable and fdrs for the weekend. Need ideas!!
  16. ECU module programming guide using FDRS

    Why avoid an IPMA PMI normally?
  17. ECU module programming guide using FDRS

    i suggested he do a PMI. Thanks, but I’m in Canada, shipping cost and time would be crazy.
  18. ECU module programming guide using FDRS

    thats from the widget and it was downloaded moments before I posted
  19. ECU module programming guide using FDRS

    Here is my IPMA module I for if that helps


Top