barlow
Member
- Thread starter
- #1
Hi all, I have 2 cracked tail light lenses, including one with the dreaded "water in radar sensor" issue. Turning off the cross-traffic warning failure alert is a chore I do every few minutes now.
I am not ready to shell out $3k for these lenses.
I am not very psyched to buy red tape at Autozone and make this truck look like it's been fixed with tape.
So: if anyone out there with a 3D printer has tackled this project, how did it go? No question it's a complex one, but :
https://www.ecosia.org/images?q=3d printed taillight lens
Anyone working on this, or up for trying?
I am not ready to shell out $3k for these lenses.
I am not very psyched to buy red tape at Autozone and make this truck look like it's been fixed with tape.
So: if anyone out there with a 3D printer has tackled this project, how did it go? No question it's a complex one, but :
https://www.ecosia.org/images?q=3d printed taillight lens
Anyone working on this, or up for trying?
Sponsored
