3D printed tail light lenses?

[barlow]

Hi all, I have 2 cracked tail light lenses, including one with the dreaded "water in radar sensor" issue. Turning off the cross-traffic warning failure alert is a chore I do every few minutes now.

I am not ready to shell out $3k for these lenses.

I am not very psyched to buy red tape at Autozone and make this truck look like it's been fixed with tape.

So: if anyone out there with a 3D printer has tackled this project, how did it go? No question it's a complex one, but :
https://www.ecosia.org/images?q=3d printed taillight lens

Anyone working on this, or up for trying?

Sponsored

 

[Mmiketa]

Printing clear is definitely a challenge. Have you looked into grabbing a used one from Ebay? They're way under MSRP.