Ford Pro charger rear entry how?

[Gato Meoow]

I am installing the Ford Pro Charger, this is my 3rd charger install and doing the rear entry makes no sense.

I have 1” conduit coming directly out of the house where it comes out into the cutout of the base.

The charger has that 1” opening which has a rubber grommet. So I can

A) how to I terminate the PVC conduit with just the wires coming out and then to the grommet. I guess I could use some kind of foam watertight collapsing fitting? This is a pain to find.

B) why can’t you do the obvious which is have a fitting that goes straight in when you slide back the charger on to the base. But the fitting is set at a 45’ angle so tha can’t happen.

anyone else do there rear install? How did you do it.

Sponsored

 

[irunalot]

I did an indoor installation with rear entry. Because it was in an unfinished garage, I could run the 2ga wire up from the bottom, it made a u-turn behind the charger and then down into the charger at the 45-degree angle. I didn't need anything waterproof so I used a standard 1" electrical connector (pictured) and it secured the installation quite well. The local inspector was happy with the install. I'm guessing the odd rear entry facilitates easier indoor application. I would also have struggled doing an outdoor install.