Henry Ford
Well-known member
... because it's known to cause cancer in the state of California.So, w/o a third brake light I believe they would be illegal in California.

Sponsored
... because it's known to cause cancer in the state of California.So, w/o a third brake light I believe they would be illegal in California.
Would the light bar in the center of the tailgate count as the 3rd brake light?So, w/o a third brake light I believe they would be illegal in California.
Has to be a CHMSL and the tail gate isn’t that high compared to the roof. Also has to be mounted to a fixed part of the vehicle that cannot be easily removed. Tailgates and bed caps can easily be removed. If you drill into traffic safety analysis, CHMSL have been effective in light trucks.Would the light bar in the center of the tailgate count as the 3rd brake light?
... because it's known to cause cancer in the state of California.![]()
And even then it does little/nothing to improve efficiency...If someone really wanted to increase efficiency they'd add a topper that starts at the back of the cab and extends all the way to the tip of the open tailgate. Even then, it would take a lot of luck or access to a wind tunnel to get the shape right to maintain laminer flow over the entire surface.
Only if you eat it.... because it's known to cause cancer in the state of California.![]()
Did you read the Motor Trend article that you linked? Nowhere does it state that an aero cap would do nothing to increase efficiency. In fact it states that it certainly WOULD, although the real-world testing conditions they faced during the short time they had to test the aero cap meant that they didn’t observe the increase that “virtualwind tunnel”testing indicated was possible. Honestly, MT should be embarrassed by this article- they are comparing their measured efficiency in poor weather conditions and with a faulty air dam to their aggregate efficiency over the prior 1300 miles of driving, which is a pretty worthless comparison. Someone needs to test the aero cover over the same route in the same weather conditions (two identical Lightning trucks - same wheels/tires, same trim would be ideal) against a Lightning with no tonneau cover, and see the results. I would imagine that we would see a significant improvement- a decrease of drag coefficient of 20% would not be nothing. Might increase efficiency by 5% or more, but again, we won’t know until someone does a proper analysis.And even then it does little/nothing to improve efficiency...
https://www.motortrend.com/reviews/...ing-xlt-yearlong-review-update-9-aerodynamics
I don’t think it’s accurate to simply say that there’s no possibility of aerodynamic changes from adding a bed topper. Yes, it moves the low-pressure area further back, but depending on the shape of the topper and the speed of the vehicle moving through the air, it’s not accurate to say that the low pressure area would be identical. It clearly is possible that a topper could reduce the COD, although I would agree that the amount of reduction would likely be low enough to not have a significant effect on efficiency.There is no aerodynamic explanation for any gain of efficiency by adding a bed topper, much less an 18% gain. All the topper does is move a low pressure area from behind the cab to behind the topper.
Ford claims the wide tailgate top reduces the low pressure area behind the cab so you're probably reducing efficiency by adding any bed cover.
If someone really wanted to increase efficiency they'd add a topper that starts at the back of the cab and extends all the way to the tip of the open tailgate. Even then, it would take a lot of luck or access to a wind tunnel to get the shape right to maintain laminer flow over the entire surface.
Already been done. It looks like a dumpster. But certainly more aero.Waiting for someone to design a replacement, angled front hood that will improve aerodynamic efficiency...
It's possible a bed topper could improve aerodynamics on a truck but extremely unlikely unless it was designed specifically for that purpose. I put the odds of me getting a hit off Tarik Skubol in the same category as an aero bed topper.I don’t think it’s accurate to simply say that there’s no possibility of aerodynamic changes from adding a bed topper. Yes, it moves the low-pressure area further back, but depending on the shape of the topper and the speed of the vehicle moving through the air, it’s not accurate to say that the low pressure area would be identical. It clearly is possible that a topper could reduce the COD, although I would agree that the amount of reduction would likely be low enough to not have a significant effect on efficiency.
Sorry, you're absolutely right, I should have just said "little" instead of "little to nothing", my bad.Did you read the Motor Trend article that you linked? Nowhere does it state that an aero cap would do nothing to increase efficiency.