F150 Lightning FORScan thread - Version 2

[rugedraw]

I've tried that many times with different GPT levels and Grok and Gemini. They all hallucinate and make shit up. I'd be willing to try it again if I can get someone's as built directly off of their truck, but I am starting to have a feeling the APIM or DSP modules are different from Platinum to Lariat.


Many have tried that and it doesn't work, I have the toggle on my screen but still no sound. If I hit the toggle, it turns the toggle on for two seconds, thinks about it, and then fails and turns itself off.

This is sounding a bit familiar now. I remember seeing this at some point, too. I think there's a hardware element to this. Some physical component that the higher trims have........I can't remember the exact details. I'm sure someone will chime in on it.

Sponsored

 

[bmwhitetx]

Many have tried that and it doesn't work, I have the toggle on my screen but still no sound. If I hit the toggle, it turns the toggle on for two seconds, thinks about it, and then fails and turns itself off.

Historically, an APIM-enabled toggle that won’t stay on was due to missing hardware or older firmware. PPOB with truck off and IIRC BC Lane Change Assist did this until other modules were updated.

This is sounding a bit familiar now. I remember seeing this at some point, too. I think there's a hardware element to this. Some physical component that the higher trims have........I can't remember the exact details. I'm sure someone will chime in on it.

Yep, has been tried before. Needs hardware. Not a software only mod. Jesse explains here. https://www.f150lightningforum.com/forum/threads/propulsion-sound.22894/post-530473

 

[Paulb55]

Historically, an APIM-enabled toggle that won’t stay on was due to missing hardware or older firmware. PPOB with truck off and IIRC BC Lane Change Assist did this until other modules were updated.

Yep, has been tried before. Needs hardware. Not a software only mod. Jesse explains here. https://www.f150lightningforum.com/forum/threads/propulsion-sound.22894/post-530473

Thanks. Saved me time today.

 

[SFsparkie]

Can FORScan adjust GSM rotary shifter?. After problems with the OEM GSM on my Lariat (But no DTCs) I installed a new Mach-E rotary shifter. Car drives/shifts fine but there are network communication DYCs: U0203 from GSM, U0404 from ABS and instrument panel says Auto Hold System Fault. I noticed the ABS FORScan spreadsheet does show (760-02-02 xx*x xx—) Gear Shift Type (GST). But all choices read “Not Used). Is there anything That can be done to clear the DTC. (Currently will not clear). When I open the door in drive the shifter moves to Park__this may have been the predecessor to the Auro Hold System Fault. Fault remains after several drive cycles.

 

[21st Century Truck]

Can FORScan adjust GSM rotary shifter?. After problems with the OEM GSM on my Lariat (But no DTCs) I installed a new Mach-E rotary shifter. Car drives/shifts fine but there are network communication DYCs: U0203 from GSM, U0404 from ABS and instrument panel says Auto Hold System Fault. I noticed the ABS FORScan spreadsheet does show (760-02-02 xx*x xx—) Gear Shift Type (GST). But all choices read “Not Used). Is there anything That can be done to clear the DTC. (Currently will not clear). When I open the door in drive the shifter moves to Park__this may have been the predecessor to the Auro Hold System Fault. Fault remains after several drive cycles.

The rotary shifter from the Mach E doesn't fully work on the Lightning. I tried one and wrote up the results here about a year ago.

 

[B177y]

Can FORScan adjust GSM rotary shifter?. After problems with the OEM GSM on my Lariat (But no DTCs) I installed a new Mach-E rotary shifter. Car drives/shifts fine but there are network communication DYCs: U0203 from GSM, U0404 from ABS and instrument panel says Auto Hold System Fault. I noticed the ABS FORScan spreadsheet does show (760-02-02 xx*x xx—) Gear Shift Type (GST). But all choices read “Not Used). Is there anything That can be done to clear the DTC. (Currently will not clear). When I open the door in drive the shifter moves to Park__this may have been the predecessor to the Auro Hold System Fault. Fault remains after several drive cycles.

Whole thread about which shifters work in the Lightning here.

 

[rugedraw]

Livnitup added the changes needed to enable BC 1.4 to the F150 spreadsheet common tab. Same applies to the 2022-2023 Lightnings. As @bmwhitetx noticed a while back ago, the only difference between the F150 and the Lightnings is to use an E here instead of a 4 to maintain key detection alert and FRD (frunk related) as it should be for a Lightning:

7D0-09-05

xxxx xxEx xxxx

This will not work if your IPMA is not updated to the latest version and this will not work if you do not have an active Bluecruise subscription and the hardware needed for BC to work.

Edit: The changes needed to enable this in vehicles outside American markets may be different, so check what values are there against the spreadsheet before attempting to make sure you don't enable/disable something that isn't supposed to be changed.

 

[bmwhitetx]

Livnitup added the changes needed to enable BC 1.4 to the F150 spreadsheet common tab. Same applies to the 2022-2023 Lightnings. As @bmwhitetx noticed a while back ago, the only difference between the F150 and the Lightnings is to use an E here instead of a 4 to maintain key detection alert and FRD (frunk related) as it should be for a Lightning:

7D0-09-05

xxxx xxEx xxxx

Edit: Waiting on clarification if this change below needs to be made or if it should stay at 0.

7D0-09-05

xxxx xxxx x1xx

View attachment 115803

This will not work if your IPMA is not updated to the latest version and this will not work if you do not have an active Bluecruise subscription and the hardware needed for BC to work.

Edit: The changes needed to enable this in vehicles outside American markets may be different, so check what values are there against the spreadsheet before attempting to make sure you don't enable/disable something that isn't supposed to be changed.

Sweet. So you think it’s okay now for me to add to post 1 now? We’ve been sitting on this info for a long time!

 

[rugedraw]

Sweet. So you think it’s okay now for me to add to post 1 now? We’ve been sitting on this info for a long time!

Oh for sure.

 

[bmwhitetx]

Added BC 1.4 to post 1. Thanks to @rugedraw for all his work on this the past few years.

 

[bc1]

Sorry but it's been a while since I've read through this thread and my memory is bad. Is there anyway to turn off the annoying keep your hands on the steering wheel warning which I get on a straight stretch of road with the cruise on? Same for the keeps eyes on the road warning when I'm looking for a particular store, etc?

 

[rugedraw]

Sorry but it's been a while since I've read through this thread and my memory is bad. Is there anyway to turn off the annoying keep your hands on the steering wheel warning which I get on a straight stretch of road with the cruise on? Same for the keeps eyes on the road warning when I'm looking for a particular store, etc?

Yes, but if you do, Bluecruise will not work.

 

[hb.sagen]

Yes, but if you do, Bluecruise will not work.

How? Can it be used by «someone» to «disable» BC in a covert way?

 

[rugedraw]

How? Can it be used by «someone» to «disable» BC in a covert way?

No, this can only be done by plugging in with FORScan and manually disabling highway assist in favor of traffic jam assist. Basically, he would have to change his IPMA setting to what yours had before you made the changes I sent you.

 

[Dahveed]

Sorry but it's been a while since I've read through this thread and my memory is bad. Is there anyway to turn off the annoying keep your hands on the steering wheel warning which I get on a straight stretch of road with the cruise on? Same for the keeps eyes on the road warning when I'm looking for a particular store, etc?

If you're not using BlueCruise, you can just turn off lane centering.

Sponsored