bmwhitetx
Well-known member
This update was supposed to add them but lot of folks are reporting it didn't. You can wait until Ford does a replacement OTA or enable them with FORScan.What do I do if I don’t see this section?
Sponsored
This update was supposed to add them but lot of folks are reporting it didn't. You can wait until Ford does a replacement OTA or enable them with FORScan.What do I do if I don’t see this section?
I agree with you about the drive experience, best vehicle I have driven and I own a Tesla, but Ford needs to understand that software goes hand in hand with an electric vehicle. I am assuming the point of spending millions of dollars on development and research is to successfully CONTINUE to sell the electric truck right? I have to admit that Tesla swallows Ford whole when it comes to the software side of these vehiclesYeah but they won't do that unless they are being paid to do other things. I tried twice already - and they were even doing other things on my truck. So screw it, I don't really care so much about that feature to beg for it. Yet another failed experience with Ford (again, thankfully the driving experience is so damn good)
I have been in this boat. For the last 6 months I've owned my used truck the doors have just locked when I walked away. No toggle in the system.Yes it is rolling out to non EAP.
Funny thing though, I had a BCM update recall last week and the dealer updated it at the dealer. I found I had WAL after I came home and found the truck had locked on its own.
Today I received the OTA update that said it enabled WAL (it has been working for a week.). It did not add the Contol option in the Lock Screen within the sync system that I can find though.
Hey I’m just thrilled that it defaulted to on.I have been in this boat. For the last 6 months I've owned my used truck the doors have just locked when I walked away. No toggle in the system.
Today got this update. Still no toggle
Well I received the update and it defaulted to off. And yes I have the factory keypad...Hey I’m just thrilled that it defaulted to on.![]()
Good question.Well I received the update and it defaulted to off. And yes I have the factory keypad...
I do have the approach feature turned off... I wonder if it's tied to that feature as the way to enable or disable WAL.
I mis represented the "welcome lighting" feature as the Approach... That is what I have turned off. I'll test tomorrow to see if that's the trick to activate the WAL.Good question.
I don’t have unlock on approach, just the lock on walk away.. That’s a good thing for me since I didn’t get the controls.
What is the OTA number at the bottom of the screen?Looks like I just got it. Will test it out later.
![]()
What is the OTA number at the bottom of the screen?