ECU module programming guide using FDRS

["Steve"]

well shoot.

Sponsored

 

["Steve"]

getting stuck here. right off the get go.

usb cable to 5pin in apim.

 

[JIMFOUNTAIN]

Hey Jim. Check your settings in Sync to make sure your kick switch is enabled as some of these updates reset these modules. If they still don't work check your ForScan settings on 744-23-01 and see if the following is enabled XXXX-XX01-00 and do a module reset after and your kick switch should work. Hope this helps.

Well at least there is a pattern for me. When I updated to Bluecruise the DSM update wiped out my running board settings. Set back 744-23-02 and boards worked but kick switch did not. Latest DSM update wiped the settings again. So

744-23-02

01xx

xxxx

xx

sez I have running boards... now working again. Then I found

744-23-01

xxxx

xx01

xx--

and it sez kick switch is present. Kickswitch works properly now that this bit is set.

Not sure why some trucks get the running board config reset upon a DSM update and some do not. But that is clearly the case. I suspect Ford will be replacing a number of kick switches and maybe even running boards as the dealers do more and more Bluecruise updates.... since their techs don't have access to Forscan spreadsheets, @Jesse-Infotainment , @Livnitup , etc and this invaluable forum.

 

[SharkAttack]

The guide used to say that windows VMs on a Mac were known to cause problems. It's gone now. Does that mean that some people have had some success updating on a VM?

 

[JJ_Tex]

Steve - Did you get unstuck. I just threw in the towel on the dealer and ordered the mongoose.

 

["Steve"]

no, cant get past the fastboot issue. something wrong with drivers or something? maybe an old laptop?

 

[JJ_Tex]

Did you check the latest TSB put out by Ford? They mentioned which cables worked and which brands did not. I'll dig into it more once I get my equipment. Good luck.

Edit - Attached is the latest document from Ford from Wed.

 

["Steve"]

i think so. pretty sure i got all the right stuff.

 

[ColoradoHunter]

Here is the link to TSB 22-2150 that lists the good and bad USB to Ethernet adapters. https://www.macheforum.com/site/attachments/tsb-22-2150-pdf.61536/

 

["Steve"]

looks like im good there.

 

[antho]

looks like im good there.

May sound stupid but close FDRS and open it again with the cables connected. Worth a shot..

 

["Steve"]

^i've tried a few different things and nothing has been successful yet. might have to try the desktop....outside.

 

[JJ_Tex]

Hey Steve - The table below shows the various error messages and actions on page 18 of the TSB. I think your error is the last one.

 

["Steve"]

saw that. tried other cables. no dice.

desktop worked though....until a widespread cox outage shut me down. the first module repair process completed though. ill be at it again tomorrow. there is hope.

 

["Steve"]

round 3. fight.

Sponsored