ECU module programming guide using FDRS

[Kanuck]

I wonder if Ford found a bug in the update and pulled it. I had a message on Ford Pass and had the dealer do the update. Questioned him on the fact that the recall update was not out yet and he swears up and down it was. Ford Pass is not showing the recall now.

Sponsored

 

[Shoebox72069]

I'll see what the bell weather around here polls in a few days/week and then call up the dealership and have a fun conversation with them. Good times!

 

[rpeterslll]

I had the dealer put my VIN in FDRS and they said I had a TRM update available. I updated March 21st already. I’ll have them do it and see what I get.

 

[Ruffiano99]

anyone else get this message while trying to pull up their vehicle history on FRDS? My truck is at the dealer, trying to check in and see what progress (or lack of) has been made.

 

[BlackSheep]

Check out this post for the version of software required to address the TRM recall.

https://www.f150gen14.com/forum/thr...-campaign-nhtsa-22s17-22v193.9742/post-200916

 

[rpeterslll]

check out this post for the version of software required to address the recall

https://www.f150gen14.com/forum/thr...-campaign-nhtsa-22s17-22v193.9742/post-200916

Yup. We need ML3T-19J297-DH to fix the TRM problem. Has anyone reported this version yet?
Attached is the documents.

 

[BlackSheep]

Yup. We need ML3T-19J297-DH to fix the TRM problem. Has anyone reported this version yet?
Attached is the documents.

I installed the latest version available in FDRS today and the last two were BB, see below:

 

[rpeterslll]

I installed the latest version available in FDRS today and the last two were BB, see below:

very weird!! Why aren't we getting the new version???

 

[BlackSheep]

very weird!! Why aren't we getting the new version???

My guess is it hasn’t released or they had to pull it back due to an issue.

 

[Mike G]

anyone else get this message while trying to pull up their vehicle history on FRDS? My truck is at the dealer, trying to check in and see what progress (or lack of) has been made.

Nope, just checked mine, all ok.

But it has choked in the past at times.....

Mike

 

[El Amigo]

same here updated TRM

 

[rpeterslll]

I can’t understand why they would be still loading a known faulty s/w version then. And oasis/PTS would have a notification if this was the case too.

 

[Mike G]

Anybody run into any problems with the new version of FDRS yet..31.6.7?

Mike

 

[abd79]

No problems with latest version of FDRS here. Just did PCM on job 1 powerboost.

Also no TRM update shown and likely won’t be until the 18th. My versions are a bit different then others on here, see attached.

 

[Mike G]

Recommending anybody having issues with updating modules in FDRS check this thread from the Mach-E sister site. Thread mentions Bluecruise maps update but that's only part of what it's about. That CSP 22P08 ought to be a sticky:

https://www.macheforum.com/site/threads/csp-22p08-bluecruise-map-expiration-update.16563/

Mike

Sponsored